Technical Specifications
|
Item |
Detail |
|
Applications |
Covers, flanges, ducts, housings, and access plates |
|
Product form |
Die-cut sheet gasket or molded rubber gasket |
|
Materials |
Silicone, FKM, EPDM, or another confirmed compound |
|
Production basis |
Drawing, dimensions, tooling, or old sample |



Repeated heat changes an ordinary gasket
A standard rubber gasket can seal correctly during the first run. After repeated heating and cooling, it may lose recovery, harden along the hot edge, or stay compressed around the bolts. The joint then has to be opened again even though the metal parts are usable.
A high temp rubber gasket is bought to keep that maintenance from returning too soon. Its value is not simply a higher temperature figure. The rubber must hold compression while the metal expands, cools, and clamps against it again.
We often see the change first at the inner edge. The outer face may still look normal, while the hot side has become glossy, brittle, or thinner. Bolt holes can stretch when a hardened sheet is removed. Those marks show why copying only the outside shape is not enough.


The gasket still has to fit properly
Heat resistance cannot make up for uneven thickness, rough holes, or a narrow bridge cut too close to the edge. On a bolted cover, these details affect load spread. A cleanly cut or molded part sits flat before tightening and is less likely to be damaged during fitting.
Each high temp rubber gasket is made for the existing joint as a flat sheet profile or molded shape. Material choice follows the heat cycle and the medium at the sealing face. The result is a replacement for a hot joint, not the nearest available rubber.


Quote Notes
Send the drawing or old sample, dimensions, thickness, bolt-hole layout, contact medium, working temperature, material requirement, quantity, and packing reference.
Hot Tags: high temp rubber gasket, China high temp rubber gasket manufacturers, suppliers, factory