Technical Specifications
|
Item |
Detail |
|
Product form |
Ring, washer, flange gasket, or flat custom profile |
|
Production |
Die-cut, machined, or pressed to finished shape |
|
Material |
Virgin, modified, or filled PTFE |
|
Finished features |
Bore, outside contour, slots, and mounting holes |


Clean edges matter more on PTFE
The quality of a ptfe flat gasket is visible around the bore and the narrow sections. A clean inner edge stays round, with no white feather, dragged material, or loose sliver left on the sealing face. The outer contour follows the same centre, so the sealing width does not become thin on one side and heavy on the other.
That even geometry makes the part easier to place. Bolt holes line up without pulling the gasket sideways, slots remain open, and narrow bridges keep enough material to sit flat between the mating faces. On small washers, the difference is seen in the bore. On larger flange shapes, it shows in the way the ring settles around the studs without being pushed back into position.
Thickness is checked across the working area rather than at one convenient edge. The faces also remain free of deep tool marks. The result is a flat sealing surface that closes evenly, instead of a part with one proud section forcing the rest of the joint to follow it.



Packing should not undo the machining
A finished PTFE gasket can be damaged after machining if it is bent too sharply or packed under heavier parts. Large thin rings are therefore supported across the body, while smaller pieces are kept from folding through one another. Holes, tabs, and narrow necks remain open and undistorted.
The second selling point of the ptfe flat gasket is that nothing important is left unfinished. The bore is already clean, the outer shape is complete, and the sealing width has not been reduced by corrective trimming. There are no loose cuttings to remove from the surface and no curled edge to press down while the joint is being closed.
For repeat production, the same profile returns with the same relationship between bore, outside contour, holes, and thickness. That consistency is what makes the part useful in maintenance stock and assembly work: it sits where expected, keeps its full contact width, and reaches the joint in a condition that does not need correction.


Quote Notes
Send the drawing or original dimensions, thickness, bore and hole layout, PTFE grade, contact medium, quantity, and packing requirement.
Hot Tags: ptfe flat gasket, China ptfe flat gasket manufacturers, suppliers, factory