High Temp Silicone Exhaust Hose

Send Inquiry
High Temp Silicone Exhaust Hose
Details
This high temp silicone exhaust hose is used around heater boxes, heat shields, and hot-air outlets where the hose end sits close to clamps, beads, brackets, and warm metal.
The clamp area stays straight enough for the band to press on a round section.
The silicone wall supports elbows and reducers through heat cycles.
Trimmed mouths help the hose pass over pipe beads without folding at the lip.
Used hoses are read for hard ends, bead rings, clamp cuts, and narrowed bends.
Category
High Temp Silicone Hose
Share to
Description

Technical Specifications

 

 

Factory worksheet

What is written down

Hose mouth

ID, OD, wall thickness, straight end length, clamp width, and bead contact mark.

Formed body

Bend angle, reducer step, hose length, bracket, and heat-side direction.

Service boundary

Hot-air or exhaust-adjacent connection only; not raw exhaust gas, fuel, oil, hydraulic oil, or flame.

 

Flexible High Heat Exhaust Duct

High Temperature Air Transfer Hose

 

A sample should still show where it worked

 

 

A hose that has been clamped behind a shield often tells more than a clean drawing. The hot end may feel dry and firm, while the cooler end still springs back. Inside the mouth, a rubbed ring can show how far the pipe bead entered. Beside the band, a small crack can show that the clamp was working too close to the bend.

 

For a high temp silicone exhaust hose, these marks decide how the next part should be built. A straight connector may only need a stable wall and a clean cut. An elbow near a bracket may need more support at the bend. A reducer may need different attention at each end because the clamp load is not the same.

 

Spiral Wire Reinforced Silicone Duct

Industrial Exhaust Ventilation Silicone Hose

 

The hose mouth decides the fit

 

 

When the straight section is short, the clamp can sit partly on the curve. The mouth then starts to lose its round shape. A soft wall can take a deep groove. A heavy wall may stop the hose before it passes fully over the bead.

 

VANSER can work from a used hose, drawing, or installed photo. For formed parts, the photo shows the heat shield, bracket, bead position, and real bend direction.

 

Silicone Coated Fiberglass Exhaust Hose

Silicone Hose Internal Fabric Structure

 

Hot-air routing is not exhaust gas

 

 

This high temp silicone exhaust hose is for hot-air routing or equipment close to exhaust heat. It is not a direct raw-exhaust gas hose. Outside heat, carried gas, oil vapor, and fuel exposure age silicone differently.

 

Quote Notes

 

 

Useful data includes ID, OD, wall thickness, length, bend angle, straight end length, clamp width, bead size, heat distance, shield condition, medium, sample, drawing, quantity, and packing method.

 

Hot Tags: high temp silicone exhaust hose, China high temp silicone exhaust hose manufacturers, suppliers, factory

Send Inquiry