Polyurethane Recoil Hose

Send Inquiry
Polyurethane Recoil Hose
Details
This coiled PU air hose is used at compressed-air tool stations where the line must stretch during work, return after release, and stay off the bench or floor.
The spiral body recovers toward its coil shape after pull-and-release movement.
Straight tail ends give the coupler room to sit without bending at the first coil.
The PU wall keeps the hose light for hand tools and assembly benches.
Connector-ready ends can be supplied when fitting type and tail length are fixed.
Category
Polyurethane Hose
Share to
Description

Technical Specifications

 

 

Hose area

Production note

Coil body

Coil diameter, relaxed length, and working pull range matched to the station.

Tail end

Straight tail length, connector position, and fitting direction kept away from the first coil.

Hose build

PU hose with ID, OD, wall thickness, color, and coil memory recorded for repeat supply.

Air-line use

Compressed-air tools and workstation air supply; not fuel, steam, solvent, hydraulic pressure, or exhaust heat.

 

coiled air hose recovery

 

Made for tool movement

 

 

A recoil hose keeps the air line close to the workstation. The worker pulls the tool out, uses it, and releases it without leaving a long loose hose across the bench. The coil should return neatly enough that the next movement starts cleanly.

 

For a polyurethane recoil hose, the coil is only one part of the product. The two straight tails matter just as much. If the tail is too short, the coupler takes the pull instead of the hose body. After use, that end can show a sharp bend near the fitting.

 

straight tail air hose

air hose connector protection

 

Coil memory and working reach

 

 

The full stretched length is not the same as a good working length. A hose may stretch far once by hand, but daily use at that distance weakens the coil memory. A bench air tool, a hanging tool, and a compressor outlet extension all move differently.

 

A better hose reaches the normal work area without dragging on the floor or rubbing one bench edge. A polished side on an old coil, a flat dirty spot, or a twisted tail usually shows where the station layout was fighting the hose.

 

pneumatic hose working reach

 

Supply form

 

 

VANSER supplies polyurethane recoil hose for air tools, assembly benches, workstation air lines, and compressor outlet extensions. Connector-ready ends, color, and packing length can follow the approved sample.

 

quick coupling air line

 

Quote Notes

 

 

Useful order data includes ID, OD, wall, relaxed coil length, working pull length, coil diameter, tail length, connector type, air pressure, color, quantity, and packing method.

 

Hot Tags: polyurethane recoil hose, China polyurethane recoil hose manufacturers, suppliers, factory

Send Inquiry