Motor Vibration Mounts

Send Inquiry
Motor Vibration Mounts
Details
Motor vibration mounts are rubber-metal support parts fitted under electric motor feet, pump frames, fan bases, and machinery beds where installed height and bolt alignment affect equipment stability.
The bonded rubber body sits between the motor foot and the base frame.
Studs, plates, or threaded inserts are formed to match the mounting holes.
Rubber height and hardness help control vibration without changing the shaft line.
Position-packed parts can separate motor side, pump side, fan side, or buyer code.
Category
Anti Vibration Mounts
Share to
Description

Technical Specifications

 

 

Mount area

Product detail

Mount form

Stud mount, plate mount, sandwich mount, cylindrical mount, or custom rubber-metal support.

Rubber and metal

NR, CR, NBR, or EPDM with steel plate, stud, sleeve, washer, or specified insert.

Fit dimensions

Rubber height, rubber diameter, bolt size, thread length, plate size, and hole spacing.

Working position

Electric motor foot, pump-motor unit, fan base, machinery bed, small generator frame, or equipment support point.

engine bracket mounting position

Motor base fit

 

 

An electric motor mount works under a different condition from a general rubber pad. The motor foot is bolted down, and the shaft usually connects to a pump, fan, pulley, or coupling. The mount has to reduce vibration, but it also has to keep the motor sitting at the planned height.

 

For motor vibration mounts used in paired or four-point layouts, height difference is important. One mount sitting higher than the others can twist the motor foot. A soft or sagged mount can change coupling alignment after the equipment runs for some time. That is why rubber height, hardware position, and base contact face belong together on this product.

 

engine mount dimensional inspection

Rubber-metal structure

 

 

A rubber-metal motor mount normally uses a molded rubber body with bonded or inserted metal hardware. The stud or plate gives the installer a fixed mounting point. The rubber section gives controlled deflection under motor vibration. A clean bonding face and centered hardware help the mount sit square after tightening.

 

Small details matter on this type of part. Thread length decides whether the nut can clamp fully. Plate shape decides whether the mount sits flat on the frame. Hole spacing decides whether the part can be installed without forcing the bracket. On replacement orders, a sagged old mount should be measured together with the original installed height when that data is available.

 

engine mount mounting structure

 

Used on equipment bases

 

 

These mounts are used under electric motors, pump sets, fan units, compact generators, compressors, and small machinery bases. Oil mist, water splash, outdoor use, floor condition, and load per mount affect rubber choice. NR is common for general vibration support. CR or NBR may be used where light oil-side exposure is present. EPDM should stay away from petroleum oil contact.

 

engine mount rubber metal bonding

engine mount metal stamping workshop
engine mount quality testing

 

Quote Notes

 

 

Useful order data includes drawing or sample, rubber height, rubber diameter, bolt size, thread length, plate size, hole spacing, load per mount, equipment position, working environment, quantity, and packing method.

 

Hot Tags: motor vibration mounts, China motor vibration mounts manufacturers, suppliers, factory

Send Inquiry