Technical Specifications
|
Item |
Factory Specification |
|
Product Name |
compressor rubber mounts |
|
Product Type |
Rubber anti-vibration mount / compressor isolation support |
|
Rubber Options |
NR, CR, NBR, EPDM after load and environment review |
|
Metal Hardware |
Zinc-plated steel, stainless steel, or buyer-specified insert after review |
|
Structure Type |
Rubber foot, bonded plate mount, stud mount, washer mount, custom base |
|
Quoted Hardness |
Commonly 45–75 Shore A, depending on load and deflection |
|
Key RFQ Data |
Load per mount, bolt size, height, base diameter, drawing, environment |
|
Application Position |
Compressor foot, frame base, equipment support, small machinery mount |
|
Production Method |
Compression molding with metal bonding or rubber molding by design |
|
MOQ |
Quoted by size, rubber grade, metal hardware, and mold status |
Built for Compressor Feet and Connected Pipework
A compressor mount is not only a rubber block under the machine. It must fit the compressor foot, keep the installed height close to the requirement, and reduce vibration transfer into the frame and connected pipework.
Compared with diesel generator mounts, this page focuses on compressor feet, base height, oil mist near the compressor, and pipe connection stress. The mount should not let the compressor move enough to pull nearby lines.


Rubber and Metal Details in Production
Bolt size, stud length, hole spacing, washer size, base diameter, and rubber height affect installation more than the outside shape. A similar-looking part can fail at assembly when the metal hardware does not match the compressor foot.
For bonded mounts, VANSER quotes metal material, surface finish, rubber grade, and installed height by drawing or used sample. These are practical production details that can be controlled without promising system-level vibration design.


Replacement and Packing Control
Compressor maintenance orders may include several mounts that look similar. They can differ in rubber height, stud length, thread size, or base diameter. VANSER can pack by compressor model, foot position, buyer part number, or size.
This helps repair buyers avoid mixing parts during installation, especially when one compressor uses different front and rear mounts.


RFQ Details
Send compressor weight, support quantity, load per mount if available, bolt size, installed height, rubber diameter, metal hardware details, working environment, old sample or drawing, quantity, and packing request. VANSER will quote rubber grade, metal hardware, mold status, sample need, and lead time.
Hot Tags: compressor rubber mounts, China compressor rubber mounts manufacturers, suppliers, factory