Air Compressor Rubber Pads

Send Inquiry
Air Compressor Rubber Pads
Details
These rubber compressor pads sit under compressor feet, tank supports, and small skid frames where vibration, floor contact, oil mist, and installed height affect the base.
Dense rubber gives the compressor foot a firm seat instead of a hollow contact point.
Flat cut or molded faces help the pad sit cleanly between the base and workshop floor.
Oil-resistant rubber can be reviewed when grease marks or compressor oil mist are present.
Cut, punched, grooved, ribbed, or molded pads can follow the foot shape or old sample.
Category
Anti Vibration Pads
Share to
Description

Technical Specifications

 

 

Pad detail

Production reference

Rubber material

NBR, CR, NR, SBR, or EPDM selected by oil exposure, load, floor condition, and aging risk.

Shape supply

Flat pad, punched pad, ribbed pad, grooved pad, sheet-cut pad, or molded foot pad.

Hardness

Usually 50–80 Shore A, quoted with compressor weight, pad thickness, and contact area.

Size data

Length, width, thickness, hole position, groove depth, and expected installed height.

Use position

Compressor foot, tank support, skid frame point, belt-drive base, or workshop floor support.

 

air compressor anti vibration pads

 

Built for compressor base contact

 

 

A compressor pad does more than fill space under the base. It gives the foot a stable rubber seat and keeps metal parts away from direct floor contact. Good pad density, clean edges, and even thickness help the base sit without a soft or loose feel after tightening.

 

For air compressor rubber pads, VANSER focuses on the working area around the compressor, not only the outside pad size. A base connected to a discharge pipe, drain line, hose, belt guard, or tank frame needs the pad height to stay within a practical range.

 

industrial compressor vibration isolation pads
rubber isolation pads for compressor

 

Material should match the compressor room

 

 

Compressor rooms often have warm air, dust, oil mist, grease marks, and rough concrete floors. NBR or CR is reviewed when petroleum oil contact may affect the rubber. NR or SBR may suit dry indoor bases after load and floor contact are clear. EPDM is considered when weather or general aging is more important than oil contact.

 

An old pad can show useful wear marks. A swollen edge may point to oil exposure. A torn hole can show bolt stress. A crushed corner may come from an uneven floor. These marks help decide whether the next pad should change material, thickness, hole position, or production route.

 

compressor rubber vibration dampers

 

Cut pads and molded supply

 

 

Simple square or rectangular compressor base pads can often be cut from sheet rubber. This route works for clean edges, small batches, and basic flat shapes. Molded or punched production is better when the pad needs fixed holes, grooves, ribs, or the same profile for repeat compressor models.

 

Repeat air compressor rubber pads can be packed by size, hardness, shape, hole layout, and buyer part number. This keeps maintenance orders easier to identify when several compressor sizes are used in the same workshop.

 

air compressor shock absorbing pads

 

Quote Notes

 

 

Useful order data includes pad length, width, thickness, hardness, rubber grade, hole or groove detail, compressor weight, support point quantity, installed height, oil exposure, floor condition, drawing, old pad sample, and quantity.

 

Hot Tags: air compressor rubber pads, China air compressor rubber pads manufacturers, suppliers, factory

Send Inquiry